Tips On Replacing A Pump For A Well 

One of the first things that need to be done when deciding on replacing a well pump is to actually know if the pump is the actual issue. There are often times when the underlying problem is not the actual pump itself and no water does not necessarily equate to no pump. If there is any doubt, it is best to contact a professional repair service. This way they can diagnose the problem to see what the proper solution may be. 

If a replacement is needed, then you will need to see exactly what kind of well pumps leesburg va are needed. There are two main types of well pumps, one is a submersible pump and the other is a jet pump. Submersible pumps are mainly used in wells which are deeper. These types of pumps are also encased in a covering since they will be used underground. The other kind of well pump, known as a jet pump, are used in water that is much shallower in depth and they are used above ground so there is no need for them to be encased. You will need to find out the power rating of the pump needed as well as how many gallons per minute will need to be pumped. When buying a brand new well pump, it is crucial that you purchase the correct type of well pump. 

The next thing to do regards the actual installation of the new well pump. You will need to cut off the power supply to the old pump since you will be dealing with live electricity and water. Obviously, these two things should never be mixed as you could easily electrocute yourself. 

To turn off the power, make sure it is done at the circuit breaker. The circuit breaker will control the main source of power to the home. The well pump should be on a separate switch from the rest of the home. Make sure to take note of the correct voltage on the circuit breaker. You will need this information when it is time to install the replacement well pump. 

After everything is turned off, it will then be time to drain the water from any holding tanks that belong to the well pump. Any time a new pump is installed, the water will need to be drained from the original one. Not only does this make everything easier to move but it allows for far less of a mess to be made. 

As you can see there is not too much which needs to be done when it comes to replacing a water pump. All you need to do is follow the instructions previously stated here and you should be good to go when it comes time to switch everything out. In this way, you can make sure that everything goes according to plan and the well pump is operating at peak efficiency for maximum effectiveness for the good work.

Author :

0 thoughts on “Tips On Replacing A Pump For A Well 

Leave a Reply

Your email address will not be published. Required fields are marked *